Lightning Rodder banner
1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I have a 02 L I have already put a 4# pulley on it along with cat-back exhaust, air raid intake and predator programmer. What else can I do to increase power without affecting reliability? I don't want to open up the motor, yet. I have been told that the rods are the weak point in the motor. Is that true? How much power can you safely run with stock internals?
 

·
Banned
Joined
·
749 Posts
check out my mods and my horse power... i have no issues with reliability... look under my message down below...
 

·
Project Dirty Dog
Joined
·
6,747 Posts
I am running
4# Lower
Full Exhaust
Ported Blower
CAI
C&L Inlet
Accufab TB
Stall Converter
Gears
FTVB

Last dyno Pull numbers yet but am at 394hp with A/F of 13.0 [smilie=xyxnervous.gif]

Dyno Tune is in the works to be done


I say you will be fine with a ported blower and a Good Tune or just add a 2.8 upper
 
1 - 4 of 4 Posts
Top