Lightning Rodder banner

What did you do with your Lightning today?

836401 Views 11222 Replies 871 Participants Last post by  Certified Drunk
Like the title ask, What did you do with your L today?
Post every day or a few times a week.
  • Like
Reactions: 1
11181 - 11200 of 11223 Posts
8 more years and I won't have to do that.
If Oklahoma has a policy like that, the first I'll know it will be my 25 year old 98 Ranger. It's already less than $20 a year.
Got my Delta PAG dual 16" brushless fans after 5 months of waiting. These fans only pull 22amps at full power with soft-start feature and more CFM than my old Mark 8 fan at 70amps, also saving a few pounds with this setup.

My Mark 8 fan finally burnt up on me a few months ago so wanted to find a better solution with new brushless fan technology.

A lot of high end drag cars run these fans.

View attachment 550006
View attachment 550005
Any way to get in contact with someone to get a similar setup???
Any way to get in contact with someone to get a similar setup???
phone number is at the bottom of the page..

phone number is at the bottom of the page..

Thank you.
  • Like
Reactions: 1
If Oklahoma has a policy like that, the first I'll know it will be my 25 year old 98 Ranger. It's already less than $20 a year.

It's 30 here.

My 66, 68 and 91 all have them.
  • Like
Reactions: 1
Installed a 3.5" pulley. LOL

Tire Wheel Automotive tire Motor vehicle Vehicle
See less See more
  • Like
Reactions: 3
Installed a 3.5" pulley. LOL

View attachment 550242
But what's the bottom pulley look like lol.

Sent from my Pixel 6 Pro using Tapatalk
But what's the bottom pulley look like lol.

Sent from my Pixel 6 Pro using Tapatalk
It's only a 6lb lower.. 🤣

2.3L on top of the 3.8L


Motor vehicle Automotive design Automotive tire Vehicle Gas
See less See more
  • Wow
  • Like
  • Haha
Reactions: 5
Went to the salvage yard to get some 97 Fuel lines but ended up getting apparently some smaller ones 😭 I didn’t know it until I got home and started cleaning them lol what is the problem? Did I get some from a 4.6 f150
Got my new built engine in and fired up. Been a 3 year project.
  • Like
Reactions: 5
Those are 4.6 lines
Looks like I found the right ones
Had some ground effects clips 3d printed.

Grey Hat Font Automotive tire Gas
See less See more
  • Like
Reactions: 5
Had some ground effects clips 3d printed.

View attachment 550258
Winnnn
Lowered the output shaft of the trans by .5 degrees. lol
I'll change the oil tomorrow.
  • Like
Reactions: 2
11181 - 11200 of 11223 Posts
Top