Lightning Rodder banner
1 - 11 of 11 Posts

·
Building a fast catfish!!!
Joined
·
15,687 Posts
Discussion Starter · #1 ·
Does anyone know the thread pitch and size of the lower pulley bolt holes for mountin a one piece to the truck?

Sent via my damn droid.
 

·
Registered
Joined
·
17,565 Posts
how to section parts thread

Hub to Crank bolts for aftermarket Pulley (3)
M10-1.5x25mm
 

·
Building a fast catfish!!!
Joined
·
15,687 Posts
Discussion Starter · #3 ·
I knew I shoulda checked there... thanks stew

Sent via my damn droid.
 

·
Building a fast catfish!!!
Joined
·
15,687 Posts
Discussion Starter · #4 ·
Hey stew... you know where to purchase these specific length bolts at?

Sent via my damn droid.
 

·
Registered
Joined
·
17,565 Posts
get em at ace hardware.....true value...Napa....
 

·
Building a fast catfish!!!
Joined
·
15,687 Posts
Discussion Starter · #7 ·
Kool... I would get them at fastenal... but id have to buy a bag of a kagillion...lol

Sent via my damn droid.
 

·
Building a fast catfish!!!
Joined
·
15,687 Posts
Discussion Starter · #8 ·
And if I want I can use hex head right?

Sent via my damn droid.
 

·
Building a fast catfish!!!
Joined
·
15,687 Posts
Discussion Starter · #10 ·
Sweet... hex head stainless grade 8 with lock tight it is... any tourqe spec or is it as tight ad you can get it...lol

Sent via my damn droid.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top