Lightning Rodder banner
1 - 4 of 4 Posts

· Premium Member
Joined
·
4,924 Posts
Discussion Starter · #1 ·
According to SAE Intl. the coating is about 150 microns thick. I'm not sure until I pull the motor, but how much can be honed if the cylinders need it? How much material is removed on a light honing?
 

· Premium Member
Joined
·
4,924 Posts
Discussion Starter · #4 ·
It's about .006" thick you can hone it about 1/2 a thousandth, after that it's sleeves. We do this all the time with our Cobra Jet engine builds.
That is what I wanted to hear... thanks Jim. :bigtu

--Matt
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top