Lightning Rodder banner
1 - 4 of 4 Posts

· The Asshole from Mass
Joined
·
297 Posts
Discussion Starter · #1 ·
Installing the cylinder head temp sensor and it broke off.. wasnt even close to being tight. I HATE BRASS!

Will i be able to extract it or is the brass too soft? Its also hollow, not much material left.

Anyone got any tips on how i should go about getting this out?

Thanks
 

Attachments

· The Asshole from Mass
Joined
·
297 Posts
Discussion Starter · #4 ·
Thanks guys, luckily an extractor did the job without any issues. Got a new sensor in now and this one didn't break off! :bigtu
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top