Lightning Rodder banner
1 - 7 of 7 Posts

·
Registered
Joined
·
283 Posts
Discussion Starter · #1 · (Edited)
HELP!! CNC ported PI Windsor cylinder heads

Guys,

Can someone help me with this. right now mods are:

MP, 90MM-MAF, SBTB - 170* stat, 4# Lower, NGK Plugs, LT Headers, Full Exhaust, SCT programer.

488RWHP/535TQ.

What would the heads Painless Autoworks is selling (Ported Windsor) do for me? What cams would i need to get to 550+RWHP is this even obtainable?


Brad.
 

·
Believing Believer
Joined
·
2,179 Posts

·
Panty Dropper
Joined
·
5,911 Posts
Do you have a built bottom end?
 

·
Registered
Joined
·
283 Posts
Discussion Starter · #4 ·
No Sirs. not yet. If the heads are a good find I'd like to grab them while their available. knowing there are other heads out there. (Trick Flow) etc.


Brad.
 

·
Panty Dropper
Joined
·
5,911 Posts
Then you're already making more than you probably should be. You're on borrowed time as it is, so if you pick up his heads set them to the side and start building a motor. You'll need it sooner rather than later
 

·
Registered
Joined
·
4,809 Posts
1 - 7 of 7 Posts
Top