Lightning Rodder banner
1 - 9 of 9 Posts

·
Premium Member
Joined
·
4,058 Posts
Discussion Starter · #1 ·
Whats the size of the 4 bolts holding the drive shaft to the axle?:smt102 I'm getting ready to replace the u-joints.:bolt I hope the truck don't try to kill me again
:shocked003
 

·
Building a fast catfish!!!
Joined
·
15,687 Posts
12pt 12mm is correct

Sent from my damn droid.
 

·
2.9 Whipple E85R A1 Transmission
Joined
·
12,611 Posts
They are very tight, They have been torqued to 83lbs, gotten wet & spun dry ..and are rusted on. Just cause you got the bolts out..now the flange is rusted to the yoke.
 

·
Falafel
Joined
·
1,160 Posts
I want to make sure I have the right tools. Todd truck was abuse before me.. trust me.

+1

Mine was a friggin DD work truck before I got my hands on it.. Needed a lot of little TLC to get it up to par and its still not to where I want it..
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top