[superchargedv8]

Anyone know what the specs are for GT500 cylinder heads before the deck needs to get cleaned up?

 

[MattACK]

Don't machine shops typically shave off 5 mil, look for the low spots and go from there?

 

[superchargedv8]

Don't machine shops typically shave off 5 mil, look for the low spots and go from there?

I wanted to avoid milling them at all. Was going to put a straight edge on it and see where I was at but don't know what is acceptable at this point...ill see if i can find out.

 

[hightechredneck]

http://www.alldatadiy.com/alldatadiy/DIY~G~C41407~R0~OD~N/0/80851247/83204708/83204719/110671822/34853741/100411974/100413566/121851616/120956626
This procedure involves a precision straightedge (expensive straightedge) and a .001 feeler gauge.
http://www.alldatadiy.com/alldatadi...53741/100411974/100413566/121851616/120956626

 

[superchargedv8]

I have both of the tools. Thank you for the info:bigtu