Lightning Rodder banner
1 - 19 of 19 Posts

· Registered
Joined
·
31 Posts
Discussion Starter · #1 ·
Need an email tune to break in a new motor.

Mods:SCT X3(brand new)
-6lb pulley(brand new)
-dual 255 walbro(brand new)
-60lb inj(brand new)
-magnum powers stock internals(brand new; just not the internals)
-built MHP StgIII Short Block(brand new)
-Built heads/no port(orig heads just redone)
-SCT 2600/90mm Mass Air(brand new)
-C&L intake plenum(brand new)
-97 rail w/aeromotive fuel reg(brand new reg)
-Dynatech Headers W/high flow cats/mids and borla catback(brand new headers)
-MHP big mouth ice box(brand new)
-JLP overflow tank(brand new)
-Borla catback

Search option did not bring up much to consider......

thanks in advance to all that want to respond with helpful info!
 

· Registered
Joined
·
2,542 Posts
Eric.
 

· The Asshole from Mass
Joined
·
297 Posts
JJ @ WMS just hooked me up with mine. Runs great!
 

· Registered
Joined
·
8,520 Posts
Need an email tune to break in a new motor.

Mods:SCT X3(brand new)
-6lb pulley(brand new)
-dual 255 walbro(brand new)
-60lb inj(brand new)
-magnum powers stock internals(brand new; just not the internals)
-built MHP StgIII Short Block(brand new)
-Built heads/no port(orig heads just redone)
-SCT 2600/90mm Mass Air(brand new)
-C&L intake plenum(brand new)
-97 rail w/aeromotive fuel reg(brand new reg)
-Dynatech Headers W/high flow cats/mids and borla catback(brand new headers)
-MHP big mouth ice box(brand new)
-JLP overflow tank(brand new)
-Borla catback

Search option did not bring up much to consider......

thanks in advance to all that want to respond with helpful info!
I would be happy to help. I have been doing custom SCT tuning for over 10 years and do quite a bit of email tuning for all types of vehicles.

email me at [email protected] with a list of your mods, the tuning devices serial number and your contact information and we will get you started.

Thanks,

JJ
 

· Registered
Joined
·
31 Posts
Discussion Starter · #17 ·
I would be happy to help. I have been doing custom SCT tuning for over 10 years and do quite a bit of email tuning for all types of vehicles.

email me at [email protected] with a list of your mods, the tuning devices serial number and your contact information and we will get you started.

Thanks,

JJ
Its been a long time but I found an email tune that I got from you in 2013 that I am about to use to get the beast started that I asked for when I was hoping to get her completed then.....will update you how that goes hopefully later this week.
 

· Registered
Joined
·
8,520 Posts
Its been a long time but I found an email tune that I got from you in 2013 that I am about to use to get the beast started that I asked for when I was hoping to get her completed then.....will update you how that goes hopefully later this week.
Ok sounds good. Just make sure to email me at [email protected] if you have any questions.

Also dont forget to data log it for me, those instructions can be found in the WMS section here on LR. :bigtu

JJ
 

· Registered
Joined
·
1,072 Posts
Where do you live? If your in nc or sc I would go to Dan at prodyno. I have had good luck with his. Ran the snot out of it at vir for two days never a hiccup.
 
1 - 19 of 19 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top